Cisco Asr 1000 Series Aggregation Services Routers Sip And Spa Software Configuration Guide, Cisco Ios - Cisco ASR 1000 Series Software Configuration Manual

Finding Command Options: An Example
Table 5: Finding Command Options
Command
Router> enable
Password: <password>
Router#
Router#
configure terminal
Enter configuration commands, one per line. End with
CNTL/Z.
Router(config)#
Router(config)# interface serial ?
<0-6> Serial interface number
Router(config)# interface serial 4 ?
/
Router(config)# interface serial 4/ ?
<0-3> Serial interface number
Router(config)# interface serial 4/0 ?
<cr>
Router(config)# interface serial 4/0
Router(config-if)#
Router(config-if)# ?
Interface configuration commands:
ip Interface Internet Protocol
config commands
keepalive Enable keepalive
lan-name LAN Name command
llc2 LLC2 Interface Subcommands
load-interval Specify interval for load
calculation for an
interface
locaddr-priority Assign a priority group
logging Configure logging for interface
loopback Configure internal loopback on
an interface
mac-address Manually set interface MAC
address
mls mls router sub/interface commands
mpoa MPOA interface configuration
commands
mtu Set the interface Maximum
Transmission Unit (MTU)
netbios Use a defined NETBIOS access list
or enable
name-caching
no Negate a command or set its
defaults
nrzi-encoding Enable use of NRZI encoding
ntp Configure NTP
Router(config-if)#

Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS

XE Everest 16.5
10
Comment
Enter the enable command and password to access privileged
EXEC commands. You are in privileged EXEC mode when the
prompt changes to a "# " from the "> "; for example, Router> to
Router# .
Enter the configure terminal privileged EXEC command to enter
global configuration mode. You are in global configuration mode
when the prompt changes to Router(config)# .
Enter interface configuration mode by specifying the serial
interface that you want to configure using the interface serial
global configuration command.
Enter ? to display what you must enter next on the command line.
In this example, you must enter the serial interface slot number
and port number, separated by a forward slash.
When the <cr> symbol is displayed, you can press Enter to
complete the command.
You are in interface configuration mode when the prompt changes
to Router(config-if)# .
Enter ? to display a list of all the interface configuration
commands available for the serial interface. This example shows
only some of the available interface configuration commands.
Using Cisco IOS XE Software
OL-14127-17