Configuring Ais And Rai Alarm Forwarding For T1 On The Ceop Spa - Cisco ASR 1000 Series Software Configuration Manual

Configuring AIS and RAI Alarm Forwarding for T1 on the CEoP SPA

• Alarms cannot be suppressed in the unframed CEM mode (SAToP). Alarms received from the remote
• The forward-alarm -ais/rai- command is a hidden command and is not available in the option list. You
Configuring AIS and RAI Alarm Forwarding for T1 on the CEoP SPA
To enable AIS and RAI alarm forwarding on the SPA-24CHT1-CE-ATM and the SPA-2CHT3-CE-ATM for
T1 mode, perform the following procedure:
SUMMARY STEPS
1. Router> enable
2. Router# configure terminal
3. Do one of the following:
4. Do one of the following:
DETAILED STEPS
Command or Action
Step 1
Router> enable
Step 2 Router# configure terminal
Step 3 Do one of the following:
• Router(config)# controller t1 slot/subslot/port
•
• Router(config)# controller t3 slot/subslot/port
Step 4
Do one of the following:
• Router(config-controller)# forward-alarm
ais/rai
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
538
SAToP peer across the PSN always pass over the attachment circuit.
must type the full command.
• Router(config)# controller t1 slot/subslot/port
•
• Router(config)# controller t3 slot/subslot/port
• Router(config-controller)# forward-alarm ais/rai
•
• Router(config-controller)# t1 1-28 forward-alarm ais/rai
Configuring the Circuit Emulation over Packet Shared Port Adapter
Purpose
Enables the privileged EXEC mode. Enter your password if
prompted.
Enters the global configuration (config) mode.
Enters the controller configuration mode pertaining to the specified
slot, subslot, and port.
or
Selects the controller for the SPA port that is to be configured.
Enables AIS or RAI alarm forwarding on the selected T1 controller
interface for the 24-Port Channelized T1/E1 ATM CEoP SPA.
or
OL-14127-17