Configuring The T3E3 Atm And T1E1 Atm Spas In The Layer 3 Permanent Virtual Path (L3 Pvp) Mode - Cisco ASR 1000 Series Software Configuration Manual

Configuring a Pseudowire for an ATM Connection
DETAILED STEPS
Command or Action
Step 1
Router(config)# interface atm slot /subslot
/port.subinterface multi-point
Step 2
Router(config-subif)# atm pvp vpi
l2transport
Step 3 Router(cfg-if-atm-l2trans-pvp)# xconnect
peer-router-id vcid {encapsulation mpls
| pseudowire-class name }
Step 4 Router(cfg-if-atm-l2trans-pvp)# exit
Configuring the T3E3 ATM and T1E1 ATM SPAs in the Layer 3 Permanent Virtual Path (L3 PVP)
Mode
Perform the following steps to configure the T3E3 ATM and T1E1 ATM SPAs in the ATM L3 PVP mode:
SUMMARY STEPS
1. Router(config)# interface atm slot /subslot /port.subinterface multi-point
2. Router(config-subif)# ip address ip-address subnetmask
3. Router(config-subif)# atm pvp vpi-id
4. Router(config-subif)# pvc vpi-id/vci-id
5. Router(config-if-atm-vc)# protocol ip ip-address
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
488
Configuring the Circuit Emulation over Packet Shared Port Adapter
Purpose
Selects the ATM interface on which the pseudowire has to be configured,
where slot/subslot is the SPA slot and subslot, and /port is the SPA port on
which the interface exists.
Creates an ATM permanent virtual path for the ATM interface and assigns
a VPI to the PVP:
• vpi specifies the virtual path identifier (0 to 255).
Configures a pseudowire to transport data from the ATM interface across
the MPLS network.
• peer-router-id is the IP address of the remote PE peer router.
• vcid is a 32-bit identifier that is to be assigned to the pseudowire. The
same vcid must be used at both ends of the pseudowire.
• encapsulation mpls sets MPLS in the tunneling mode.
• pseudowire-class name specifies a pseudowire class that includes the
encapsulation mpls command.
The peer-router-id and vcid combination must be unique on the
Note
router.
Exits the interface configuration mode.
OL-14127-17