Configuring Fragmentation Size And Delay On An Mlppp Bundle - Cisco ASR 1000 Series Software Configuration Manual

Configuring the 1-Port Channelized OC-3/STM-1 SPA and 1-Port Channelized OC-12/STM-4 SPA
Command or Action
Step 4
Router(config-if)# ppp multilink group
group-number
Step 5
Router(config-if)# ppp multilink
Step 6
Repeat these commands for each interface you
want to assign to the multilink bundle.

Configuring Fragmentation Size and Delay on an MLPPP Bundle

To configure the fragmentation size on a multilink PPP bundle, use the following commands:
SUMMARY STEPS
1. Router# configure terminal
2. Router(config)# interface multilink group-number
3. Router(config-if)# multilink fragment size fragment-size
4. Router(config-if)# ppp multilink fragment-delay delay
DETAILED STEPS
Command or Action
Step 1 Router# configure terminal
Step 2 Router(config)# interface multilink
group-number
Step 3 Router(config-if)# multilink fragment size
fragment-size
Step 4
Router(config-if)# ppp multilink
fragment-delay delay
OL-14127-17
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Purpose
Assigns the interface to a multilink bundle, where:
• group-number—The multilink group number for the T1 or
E1 bundle.
Enables multilink PPP on the interface.
Purpose
Enters global configuration mode.
Creates a multilink interface and enters multilink interface mode,
where:
• group-number —The group number for the multilink bundle.
Range 1-2147483647
Sets the fragmentation size in bytes. Fragmentation is disabled by
default.
Sets the configured delay on the multilink bundle that satisfies the
fragmentation size, where:
• delay —Delay in milliseconds.
Optional Configurations
Everest 16.5
311