Cisco ASR 1000 Series Software Configuration Manual page 525

Configuring the Circuit Emulation over Packet Shared Port Adapter
Configuring the Card Type for the 2-Port Channelized T3/E3 ATM CEoP SPA
SUMMARY STEPS
1. Router # enable
2. Router# configure terminal
3. Router(config)# card type {t3 | e3} slot subslot
4. Router(config)# controller {t3 | e3} slot/subslot/port
5. Router(config-controller)# channelized mode {t1 | e1}
6. Router(config-controller)# cem-group group unframed
7. Do one of the following:
8. Router(config-controller)# atm
9. Router (config-if)# exit
DETAILED STEPS
Command or Action
Step 1
Router # enable
Step 2
Router# configure terminal
Step 3
Router(config)# card type {t3 | e3} slot subslot
Step 4 Router(config)# controller {t3 | e3}
slot/subslot/port
Step 5 Router(config-controller)# channelized mode
{t1 | e1}
Step 6 Router(config-controller)# cem-group group
unframed
OL-14127-17
• Router(config-controller)# {t1} 1-28 cem-group group timeslots 1-24
• Router(config-controller)# {e1} 1-21 cem-group group timeslots 1-31
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Purpose
Enables privileged EXEC mode.
Enters global configuration mode.
Selects a card type.
or
Use the no form of the command to remove the card type.
Selects the controller to configure the SPA port.
Effective from Cisco IOS XE Release 3.6.0S, T3 and E3
Note
card types are supported.
Swaps between the CT3-T1 and CT3-E1 modes. This is applicable
only if the card type is T3.
Creates a SAToP CEM group and configures the port for
clear-channel CEM mode.
or
To delete the CEM circuit and release the time slots, use the no
cem-group group-number command.
Configuring Port Usage: An Overview
Everest 16.5
479