Saving The Configuration - Cisco ASR 1000 Series Software Configuration Manual

Configuring the Cisco WebEx Node for the ASR 1000 Series Aggregation Services Routers
ip virtual-reassembly
service-engine ip address 10.200.72.18 255.255.255.252
service-engine default-gateway 10.200.72.17
service-engine nameserver 10.100.4.10 10.100.4.20
service-engine hostname spawma1 cisco.com
service-engine wma-url https://wmabts.webex.com/wmams
service-engine wma-token 45484b3e-8ea5-41e5-b050-49409006d14e
service-engine wma-passcode SPAWMA1
0552055C271A4B5C4D5D424A5B5E007F73722B6B33264457125659500C0E555159
Because the passcode is encrypted, the output will not reveal the configured token or passcode.
Note
What To Do Next
Verify the configuration in the

Saving the Configuration

To save your running configuration to nonvolatile random-access memory (NVRAM), use the following
command in privileged EXEC configuration mode:
Command
Router# copy running-config startup-config
For more information about managing your system image and configuration files, refer to the
Configuration Fundamentals Configuration Guide
Reference
Shutting Down and Removing the Cisco WebEx Node SPA
Because the Cisco WebEx Node SPA has a hard disk drive (HDD), it is necessary to shut down gracefully
before physically removing the SPA from the Cisco ASR 1000 Series Router. This action allows the operating
system to unmount the file system and put the HDD in standby mode to prevent data corruption or physical
damage to the HDD.
The Cisco WebEx Node SPA can be shut down in one of two ways:
• You can use the hw-module subslot stop command to gracefully shut down the SPA before physically
Command
Router# hw-module subslot slot/subslot stop
OL-14127-17
Verifying the Service Engine Configuration, on page
publications that correspond to your Cisco IOS XE software release.
removing the hardware from the chassis. To shut down the Cisco WebEx Node SPA, use the following
command in EXEC mode:
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Purpose
Writes the new configuration to NVRAM.
and Cisco IOS Configuration Fundamentals Command
Purpose
Shuts down the Cisco WebEx Node SPA located in
the slot and subslot locations indicated.
Saving the Configuration
362.
Cisco IOS XE
Everest 16.5
361