Configuring A Cem Class (Optional) - Cisco ASR 1000 Series Software Configuration Manual

Configuring a CEM Class (Optional)

Command or Action
Example:
Router(config)#
Example:
Router(config-controller)#
1 unframed
Step 3 Router(config-controller)# exit
Configuring a CEM Class (Optional)
To assign CEM parameters to one or more CEM interfaces, create a CEM class (template) that defines the
parameters, and then apply the class to the interfaces.
CEM class parameters can be configured directly on the CEM circuit. The inheritance is as follows:
• CEM circuit (highest level)
• Class attached to CEM circuit
• Class attached to the CEM interface
If the same parameter is configured on the CEM interface and the CEM circuit, the value on the CEM circuit
takes precedence.
To configure a CEM class, perform the following steps:
SUMMARY STEPS
1. Router# configure terminal
2. Router(config)# class cem name
3. Router(config-cem-class)# command
DETAILED STEPS
Command or Action
Step 1
Router# configure terminal
Step 2
Router(config)# class cem name
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
500
controller t3 3/2/1
e1 1 cem-group
Purpose
Enters the global configuration mode.
Creates a CEM class to configure the parameters in a template and apply the
parameters at the CEM interface level.
Configuring the Circuit Emulation over Packet Shared Port Adapter
Purpose
• timeslots timeslots specifies the time slots to be included in the
CEM circuit. Use this keyword for the CESoPSN mode. The list
of time slots can include commas and hyphens with no spaces
between the numbers, commas, and hyphens.
Each time slot operates at 64
Note
kbps.
Exits the controller configuration mode.
• The name argument is a string of up to 80 characters that identifies the
CEM class. Note that the name is truncated to the first 15 characters.
OL-14127-17