Cisco Asr 1000 Series Aggregation Services Routers Sip And Spa Software Configuration Guide, Cisco Ios - Cisco ASR 1000 Series Software Configuration Manual

Verifying the Interface Configuration
For information about managing your system images and configuration files, refer to the
Configuration Fundamentals Configuration Guide
Reference
Verifying the Interface Configuration
Besides using the show running-configuration command to display your Cisco ASR 1000 Series Routers
configuration settings, you can use the show interfaces serial and the show controllers serial commands to
get detailed information on a per-port basis for your 8-Port Channelized T1/E1 Serial SPA.
Verifying Per-Port Interface Status
To find detailed interface information on a per-port basis for the 8-Port Channelized T1/E1 Serial SPA, use
the show interfaces serial command.
Router# show interfaces serial 3/0/1:0
Serial0/3/0:0 is up, line protocol is up
Hardware is SPA-8XCHT1/E1
Internet address is 79.1.1.2/16
MTU 1500 bytes, BW 1984 Kbit, DLY 20000 usec,
Encapsulation HDLC, crc 16, loopback not set
Keepalive not set
Last input 3d21h, output 3d21h, output hang never
Last clearing of ''show interface'' counters never
Input queue: 0/375/0/0 (size/max/drops/flushes); Total output drops: 2998712
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 1744000 bits/sec, 644 packets/sec
5 minute output rate 1874000 bits/sec, 690 packets/sec
Timeslot(s) Used:1-31, subrate: 64Kb/s, transmit delay is 0 flags 2
Configuration Examples
This section includes the following configuration examples:
Framing and Encapsulation Configuration Example
The following example sets the framing and encapsulation for the controller and interface:
! Specify the controller and enter controller configuration mode
!
Router(config)# controller t1 2/0/0
!

Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS

XE Everest 16.5
234
publications for your Cisco IOS software release.
reliability 255/255, txload 240/255, rxload 224/255
180817311 packets input, 61438815508 bytes, 0 no buffer
Received 0 broadcasts (0 IP multicasts)
0 runts, 0 giants, 0 throttles
2 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 2 abort
180845200 packets output, 61438125092 bytes, 0 underruns
0 output errors, 0 collisions, 2 interface resets
0 output buffer failures, 0 output buffers swapped out
1 carrier transitions no alarm present
Configuring the 8-Port Channelized T1/E1 Serial SPA
and Cisco IOS Configuration Fundamentals Command
Cisco IOS
OL-14127-17