Saving The Configuration - Cisco ASR 1000 Series Software Configuration Manual

Saving the Configuration

Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
DSU mode 0, bandwidth 44210 Kbit, scramble 1, VC 0
Saving the Configuration
To save your running configuration to nonvolatile random-access memory (NVRAM), use the following
command in privileged EXEC configuration mode:
Command
Router# copy running-config startup-config
For information about managing your system images and configuration files, refer to the
Configuration Fundamentals Configuration Guide
Reference
Verifying the Interface Configuration
Besides using the show running-configuration command to display your Cisco ASR 1000 Series Routers
configuration settings, you can use the show interfaces serial and the show controllers serial commands to
get detailed information on a per-port basis for your 2-Port and 4-Port Channelized T3 SPA.
Verifying Per-Port Interface Status
To find detailed interface information on a per-port basis for the 2-Port and 4-Port Channelized T3 SPA, use
the show interfaces serial command.
The following example provides sample output for the serial interface on an unchannelized T3:
Router# show interfaces serial3/0/0
Serial3/0/0 is down, line protocol is down
Hardware is SPA-2XCT3/DS0
MTU 4470 bytes, BW 44210 Kbit, DLY 200 usec,
Encapsulation HDLC, crc 16, loopback not set
Keepalive set (10 sec)
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
250
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts (0 IP multicast)
0 runts, 0 giants, 0 throttles
0 parity
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 applique, 4 interface resets
0 output buffer failures, 0 output buffers swapped out
1 carrier transitions alarm present
publications that corresponds to your Cisco IOS software release.
reliability 255/255, txload 1/255, rxload 1/255
Configuring the 2-Port and 4-Port Channelized T3 SPAs
Purpose
Writes the new configuration to NVRAM.
and Cisco IOS Configuration Fundamentals Command
Cisco IOS
OL-14127-17