Cisco Asr 1000 Series Aggregation Services Routers Sip And Spa Software Configuration Guide, Cisco Ios - Cisco ASR 1000 Series Software Configuration Manual

Saving the Configuration
Command
Router(config-controller)# bert pattern {0s | 1s |
2^15 | 2^20 | 2^23 | alt-0-1} interval time
or
Router(config-ctrlr-sts1)# bert pattern {0s | 1s | 2^15
| 2^20 | 2^23 | alt-0-1} interval time
The SIPs and SPAs support many QoS features using modular QoS CLI (MQC) configuration. Since there
are no serial SPA-specific QoS features, refer to your network processor documentation for QoS configuration
information.
Saving the Configuration
To save your running configuration to nonvolatile random-access memory (NVRAM), use the following
command in privileged EXEC configuration mode:
Command
Router# copy running-config startup-config
For more information about managing configuration files, refer to the
Fundamentals Configuration Guide, Release 2
publications.
Verifying Interface Configuration
Besides using the show running-configuration command to display your Cisco ASR 1000 Series Router
configuration settings, you can use the show interface serial and the show controllers sonet commands to
get detailed information on a per-port basis for your channelized SPA.
Verifying Per-Port Interface Status
To find detailed interface information on a per-port basis for the channelized SPAs, use the show interface
serial and show controllers sonet commands.
See the
command.
The following example provides sample output for interface port 0 on the SPA located in subslot 0 of the
Cisco ASR 1000 SIP installed in slot 1of a Cisco ASR 1000 Series Router:
Router# show controllers sonet 1/0/0
SONET 1/0/0 is up.
Hardware is SPA-1XCHSTM1/OC3
IO FPGA version: 1.7, HDLC Framer version: 0

Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS

XE Everest 16.5
318
Configuring the 1-Port Channelized OC-3/STM-1 SPA and 1-Port Channelized OC-12/STM-4 SPA
Verifying the Interface Configuration, on page 304
Purpose
Sends a BERT pattern on the DS3 channel, where:
• interval time—Specifies the duration of the
BERT test, in minutes. The range is 1 to 14400.
See the DS3/T3/E3 BERT Patterns table for
Note
pattern descriptions.
Purpose
Writes the new configuration to NVRAM.
Cisco IOS XE Configuration
and Cisco IOS Configuration Fundamentals Command Reference
for an example of the show interface serial
OL-14127-17