Verifying Controller Configuration - Cisco ASR 1000 Series Software Configuration Manual

Configuring the 2-Port and 4-Port T3/E3 Serial SPA
SUMMARY STEPS
1. Router(config)# interface serial slot/subslot/port
2. Router(config-if)# ip address address mask
3. Router(config-if)# clock source {internal | line}
4. Router(config-if)# no shut
5. Router(config)# exit
DETAILED STEPS
Command or Action
Step 1 Router(config)# interface serial
slot/subslot/port
Step 2 Router(config-if)# ip address address mask
Step 3 Router(config-if)# clock source {internal |
line}
Step 4
Router(config-if)# no shut
Step 5
Router(config)# exit

Verifying Controller Configuration

Use the show controllers command to verify the controller configuration:
Router# show controllers serial 2/0/0
Serial2/0/0 -
Framing is c-bit, Clock Source is Line
Bandwidth limit is 44210, DSU mode 0, Cable length is 10
rx FEBE since last clear counter 2, since reset 0
Data in current interval (546 seconds elapsed):
Data in Interval 1:
OL-14127-17
0 Line Code Violations, 0 P-bit Coding Violation
0 C-bit Coding Violation
0 P-bit Err Secs, 0 P-bit Sev Err Secs
0 Sev Err Framing Secs, 0 Unavailable Secs
0 Line Errored Secs, 0 C-bit Errored Secs, 0 C-bit Sev Err Secs
0 Line Code Violations, 0 P-bit Coding Violation
0 C-bit Coding Violation
0 P-bit Err Secs, 0 P-bit Sev Err Secs
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Purpose
Selects the interface to configure and enters interface configuration
mode.
Sets the IP address and subnet mask.
• address—IP address.
• mask—Subnet mask.
Sets the clock source.
• internal—Specifies that the internal clock source is used.
• line—Specifies that the network clock source is used. This is
the default.
Enables the interface.
Exits interface configuration mode and returns to the EXEC
command interpreter prompt.
Required Configuration Tasks
Everest 16.5
257