Configuring Sdh For Au-3 C-11 - Cisco ASR 1000 Series Software Configuration Manual

Configuring SDH for AU-3 C-11

Command or Action
Example:
Router(config-ctrlr-tug3)#
1 timeslots 1-31
Configuring SDH for AU-3 C-11
To enable an interface under SDH framing with AU-3 mapping after configuring the SONET controller,
perform the following steps:
SUMMARY STEPS
1. Router(config)# controller sonet 0/1/0
2. Router(config-controller)# framing sdh
3. Router(config-controller)# aug mapping au-3
4. Router(config-controller)# au-3 3
5. Router(config-ctrlr-au3)# mode c-11
6. Router(config-ctrlr-au3)# tug-2 1 t1 2 cem-group 1 unframedor
DETAILED STEPS
Command or Action
Step 1 Router(config)# controller sonet 0/1/0
Step 2 Router(config-controller)# framing sdh
Step 3 Router(config-controller)# aug mapping au-3
Step 4
Router(config-controller)# au-3 3
Step 5
Router(config-ctrlr-au3)# mode c-11
Step 6
Router(config-ctrlr-au3)# tug-2 1 t1 2 cem-group 1
unframedor
Example:
Router(config-ctrlr-au3)#
2015 timeslots 1-12
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
516
Configuring the Circuit Emulation over Packet Shared Port Adapter
tug-2 1 e1 1 cem-group
tug-2 1 t1 2 cem-group
Purpose
Purpose
Selects the controller to be configured.
Specifies the framing mode.
Specifies AUG mapping.
Selects the AU-3 to be configured.
Specifies the channelization mode for the link.
Creates a SAToP CEM group.
or
Creates a CESoPSN CEM group.
OL-14127-17