Configuration Tasks - Cisco ASR 1000 Series Software Configuration Manual

Configuring the 2-Port and 4-Port T3/E3 Serial
SPA
This chapter provides information about configuring the 2-Port, 4-Port, and 8-Port Clear-Channel T3/E3
Serial SPAs on the Cisco ASR 1000 Series Routers.
•
•
•

Configuration Tasks

This section describes how to configure the 2-Port, 4-Port, and 8-Port Clear-Channel T3/E3 Serial SPAs for
the Cisco ASR 1000 Series Routers and verify the configuration. For information about managing your system
images and configuration files, refer to the following:
•
•
•
Required Configuration Tasks
This section lists the required configuration steps to configure the 2-Port and 4-Port T3/E3 Serial SPA. Some
of the required configuration commands implement default values that might be appropriate for your network.
If the default value is correct for your network, then you do not need to configure the command.
To better understand the address format used to specify the physical location of the SIP, SPA, and interfaces,
Note
see the
OL-14127-17
Configuration Tasks, page 255
Verifying the Interface Configuration, page 271
Configuration Examples, page 272
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
Cisco IOS Configuration Fundamentals Configuration Guide
Cisco IOS Configuration Fundamentals Command Reference
Specifying the Interface Address on a SPA, on page
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
17
C H A P T E R
259.
Everest 16.5
255