Configuring TE for GMPLS UNI
Configuring GMPLS UNI Controller
Perform this task to setup a GMPLS tail in MPLS-TE configuration. This task enables GMPLS UNI controller
submode to configure controllers for establishing GMPLS UNI tunnels. This is the minimal configuration
required at the tunnel tail.
Removal of the GMPLS UNI controller submode results in the immediate destruction of any GMPLS
Note
tunnel established over the controller referenced.
SUMMARY STEPS
1. configure
2. mpls traffic-eng
3. gmpls optical-uni
4. controller dwdm interface
5. Use the commit or end command.
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RP0/CPU0:router# configure
Step 2
mpls traffic-eng
Example:
RP/0/RP0/CPU0:router(config)# mpls
traffic-eng
Step 3
gmpls optical-uni
Example:
RP/0/RP0/CPU0:router(config-mpls-te)# gmpls
optical-uni
Step 4
controller dwdm interface
Example:
RP/0/RP0/CPU0:router(config-te-gmpls)#
controller dwdm 0/1/0/1
RP/0/RP0/CPU0:router(config-te-gmpls-cntl)#
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
376
Purpose
Enters global configuration mode.
Enters MPLS-TE configuration mode.
Enters GMPLS UNI configuration submode.
Enters GMPLS UNI controller submode.
Implementing GMPLS UNI