Vlan Classification - Cisco ASR 1000 Series Software Configuration Manual

VLAN Classification

DETAILED STEPS
Command or Action
Step 1
Router(config)# hw-module subslot
slot/subslot ethernet vlan unlimited
Step 2 Do one of the following:
• Router(config)# interface
gigabitethernet slot /subslot
/port.subinterface-number
• Router(config)# interface
tengigabitethernet slot /subslot
/port.subinterface-number
Step 3 Router(config-subif)# encapsulation dot1q
vlan-id
Step 4 Router(config-if)# ip address ip-address mask
[secondary]
VLAN Classification
Note When the hw-module subslot ethernet vlan unlimited command is configured, the default classification
of CoS bits 6-7 as high priority is still supported. However, other user-defined CoS values for high and
low priority classification using the plim qos input map cos queue command are not supported.
Addition of Warning Message when Enabling VLAN Scale Configuration
Effective from Cisco IOS XE Release 2.1.0S, a warning message is displayed when enabling VLAN Scale
configuration.
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
130
Purpose
(Optional) Enables configuration of up to 4094 dot1q VLANs per port
per Ethernet SPA, where:
• slot—Specifies the chassis slot number where the SIP is installed.
• subslot—Specifies the slot of the SIP where the SPA is installed.
Specifies the Gigabit Ethernet interface to configure, where:
• slot /subslot /port —Specifies the location of the interface. See the
Specifying the Interface Address on a SPA, on page
• .subinterface-number—Specifies a secondary interface (subinterface)
number.
Defines the encapsulation format as IEEE 802.1Q ("dot1q"), where vlan-id
is the number of the VLAN (1–4094).
Sets a primary or secondary IP address for an interface, where:
• ip-address —Specifies the IP address for the interface.
• mask —Specifies the mask for the associated IP subnet.
• secondary—(Optional) Specifies that the configured address is a
secondary IP address. If this keyword is omitted, the configured
address is the primary IP address.
Configuring the Ethernet SPAs
119.
OL-14127-17