Sample Configuration - Cisco ASR 1000 Series Software Configuration Manual

Configuring the Ethernet SPAs
Command
Router# network-clock clear switch {t0 | external
<slot/card/port> [10m | 2m]}
Example:
Router# network-clock clear switch t0

Sample Configuration

Configuration for QL-Enabled Mode Clock Selection
network-clock synchronization automatic
network-clock synchronization mode QL-enabled
network-clock input-source 1 interface GigabitEthernet0/2/0
network-clock input-source 1 interface ATM6/0/0
!
interface GigabitEthernet0/2/1
no ip address
clock source line
synchronous mode
end
!
interface ATM6/0/0
no ip address
atm framing sdh
no atm enable-ilmi-trap
end
Configuration for Line to External
network-clock synchronization automatic
network-clock synchronization mode QL-enabled
network-clock input-source 1 External 3/0/0
network-clock output-source line 1 interface GigabitEthernet3/0/0 External 3/0/0 e1 crc4
interface GigabitEthernet3/0/0
no ip address
no negotiation auto
synchronous mode
GPS Configuration
10MHz signal
network-clock input-source 1 External 3/0/0 10m
2M signal
network-clock input-source 1 External 3/0/0 10m
Verifying Synchronous Ethernet Configuration
Use the show network-clocks synchronization command to display the sample output as shown here:
Router#show network-clocks synchronization
Router# show network-clocks synchronization
Symbols:
Automatic selection process : Enable
Equipment Clock : 2048 (EEC-Option1)
OL-14127-17
Configuring the Network Clock for the 2-Port Gigabit Synchronous Ethernet SPA on a Cisco ASR 1000 Series Router
En - Enable, Dis - Disable, Adis - Admin Disable
NA - Not Applicable
* - Synchronization source selected
# - Synchronization source force selected
& - Synchronization source manually switched
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Purpose
Clears the forced switch and manual switch
commands.
Everest 16.5
141