Configuring Ais And Rai Alarm Forwarding For E1 On The Ceop Spa - Cisco ASR 1000 Series Software Configuration Manual

Configuring the Circuit Emulation over Packet Shared Port Adapter
Command or Action
•
• Router(config-controller)# t1 1-28
forward-alarm ais/rai

Configuring AIS and RAI Alarm Forwarding for E1 on the CEoP SPA

To enable AIS and RAI forwarding on the SPA-24CHT1-CE-ATM and the SPA-2CHT3-CE-ATM for E1
mode, perform the following procedure:
SUMMARY STEPS
1. Router> enable
2. Router# configure terminal
3. Do one of the following:
4. Do one of the following:
DETAILED STEPS
Command or Action
Step 1 Router> enable
Step 2 Router# configure terminal
Step 3 Do one of the following:
• Router(config)# controller e1
slot/subslot/port
•
• Router(config)# controller t3 slot/subslot/port
OL-14127-17
• Router(config)# controller e1 slot/subslot/port
•
• Router(config)# controller t3 slot/subslot/port
• Router(config-controller)# forward-alarm ais/rai
•
• Router(config-controller)# e1 1-21 forward-alarm ais/rai
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Configuring AIS and RAI Alarm Forwarding for E1 on the CEoP SPA
Purpose
Enables AIS or RAI alarm forwarding on the selected T1 controller
interface for the 2-Port Channelized T3/E3 ATM CEoP SPA.
Purpose
Enables the privileged EXEC mode. Enter your password if
prompted.
Enters the global configuration (config) mode.
Enters the controller configuration mode pertaining to the specified
slot, subslot, and port.
or
Selects the controller for the SPA port that is to be configured.
Everest 16.5
539