Cisco ASR 1000 Series Software Configuration Manual page 529

Configuring the Circuit Emulation over Packet Shared Port Adapter
VC idle disconnect time: 300 seconds
2 carrier transitions
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/375/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts (0 IP multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 unknown protocol drops
0 output buffer failures, 0 output buffers swapped out
Router# show atm pvc interface atm 0/1/0.1
Interface
0/1/0.1
Router# show atm interface atm 0/1/0
Interface ATM0/1/0:
AAL enabled:
Max. Datagram Size: 4528
PLIM Type: E3 - 34000Kbps, Framing is G.751 ADM, TX clocking: LINE
0 input, 0 output, 0 IN fast, 0 OUT fast
Avail bw = 34368
Config. is ACTIVE
Router# show atm interface atm 0/1/0.1
Interface ATM0/1/0.1:
AAL enabled:
Max. Datagram Size: 4528
PLIM Type: E3 - 34000Kbps, Framing is G.751 ADM, TX clocking: LINE
0 input, 0 output, 0 IN fast, 0 OUT fast
Avail bw = 34368
Config. is ACTIVE
Router# show atm pvc
VCD /
Interface
0/1/0.1
The following section displays the command outputs for the T3 mode:
Router# show atm interface atm 5/1/0
Interface ATM5/1/0:
AAL enabled: AAL5, AAL0, Maximum VCs: 2047, Current VCCs: 0
Max. Datagram Size: 4528
PLIM Type: DS3 - 45000Kbps, Framing is C-bit ADM,
DS3 lbo: short, TX clocking: LINE
Cell-payload scrambling: OFF
0 input, 0 output, 0 IN fast, 0 OUT fast
Avail bw = 44209
New Config. not yet ACTIVE
Router# show atm pvc interface atm 5/1/1.1
VCD /
Interface
5/1/1.1
Router# show atm interface atm 5/1/1.1
Interface ATM5/1/1.1:
AAL enabled:
Max. Datagram Size: 4528
PLIM Type: DS3 - 45000Kbps, Framing is C-bit ADM,
DS3 lbo: short, TX clocking: LINE
Cell-payload scrambling: OFF
0 input, 0 output, 0 IN fast, 0 OUT fast
Avail bw = 44209
Config. is ACTIVE
Router# show interfaces atm 5/1/1.1
ATM5/1/1.1 is up, line protocol is up
Hardware is SPA-2CHT3-CE-ATM, address is e804.6227.3851 (bia e804.6227.3851)
MTU 4470 bytes, BW 44209 Kbit/sec, DLY 0 usec,
reliability 255/255, txload 1/255, rxload 1/255
OL-14127-17
VCD /
Name VPI VCI Type
1 100 32 PVC
AAL5, AAL0, Maximum VCs: 2047, Current VCCs: 1
AAL5, AAL0, Maximum VCs: 2047, Current VCCs: 1
Name VPI VCI Type
1 100 32 PVC
Name VPI VCI Type
1 100 34 PVC
AAL5, AAL0, Maximum VCs: 2047, Current VCCs: 1
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Configuring Port Usage: An Overview
Peak Av/Min Burst
Encaps SC Kbps
SNAP UBR 33791
Peak Av/Min Burst
Encaps SC Kbps
SNAP UBR 33791
Peak Av/Min Burst
Encaps SC Kbps
SNAP UBR 44209
Kbps Cells St
UP
Kbps Cells St
UP
Kbps Cells St
UP
Everest 16.5
483