Cisco Asr 1000 Series Aggregation Services Routers Sip And Spa Software Configuration Guide, Cisco Ios - Cisco ASR 1000 Series Software Configuration Manual

Performing Basic Interface Troubleshooting
IP route-cache flags are Fast, CEF
Router Discovery is disabled
IP output packet accounting is disabled
IP access violation accounting is disabled
TCP/IP header compression is disabled
RTP/IP header compression is disabled
Probe proxy name replies are disabled
Policy routing is disabled
Network address translation is disabled
BGP Policy Mapping is disabled
Input features: MCI Check
WCCP Redirect outbound is disabled
WCCP Redirect inbound is disabled
WCCP Redirect exclude is disabled
To verify that your interface is operating properly, complete the following steps:
SUMMARY STEPS
1. From global configuration mode, enter the show interface atm, show atm interface atm, or show ip
interface command.
2. Verify that the interface is up.
3. Test the ability of an interface to send and receive packets.
DETAILED STEPS
Step 1 From global configuration mode, enter the show interface atm, show atm interface atm, or show ip interface command.
Example:
Router# show interfaces atm 0/2/2
Router# show atm interface atm 0/2/2
Router# show ip interface
0/2/2
Step 2 Verify that the interface is up.
Example:
Router# show interfaces atm 0/2/2
ATM0/2/2 is up, line protocol is up
Router# show atm interface atm 0/2/2
Interface ATM0/2/2:
AAL enabled: AAL5, Maximum VCs: 1023, Current VCCs: 1
Router# show ip interface brief
0/2/2
ATM0/2/2 unassigned YES manual up up
Step 3 Test the ability of an interface to send and receive packets.
Example:
Router# ping

Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS

XE Everest 16.5
94
Troubleshooting the ATM SPAs
OL-14127-17