Monitoring Per-Port Interface Statistics - Cisco ASR 1000 Series Software Configuration Manual

Configuring the POS SPAs
5 minute output rate 0 bits/sec, 0 packets/sec

Monitoring Per-Port Interface Statistics

To find detailed alarm and error information on a per-port basis for the POS SPAs, use the show controllers
pos command. For an example of the command output for a POS SPA at location 0/3/0, see the following:
router# show controllers pos
POS0/3/0
SECTION
LOF = 0
LINE
AIS = 0
PATH
AIS = 0
PLM = 0
LOP = 0
Active Defects: None
Active Alarms: None
Alarm reporting enabled for: SF SLOS SLOF B1-TCA B2-TCA PLOP B3-TCA
Framing: SONET
APS
COAPS = 0
State: PSBF_state = False
Rx(K1/K2): 00/00
Rx Synchronization Status S1 = 00
S1S0 = 00, C2 = 00
Remote aps status (none); Reflected local aps status (none)
--More--
RDOOL = 0
State: RDOOL_state = False
PATH TRACE BUFFER: UNSTABLE
Remote hostname :
Remote interface:
Remote IP addr
Remote Rx(K1/K2):
BER thresholds: SF = 10e-3 SD = 10e-6
TCA thresholds: B1 = 10e-6 B2 = 10e-6 B3 = 10e-6
Clock source: line
Configuration Examples
This section includes the following examples for configuring a POS SPA installed in a Cisco ASR 1000 Series
Router:
Basic Interface Configuration Example
The following example shows how to enter global configuration mode to specify the interface that you want
to configure, configure an IP address for the interface, enable the interface, and save the configuration. This
OL-14127-17
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts (0 IP multicasts)
0 runts, 0 giants, 0 throttles
0 parity
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 applique, 1 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
LOS = 0
RDI = 0
RDI = 0
UNEQ = 0
NEWPTR = 0
PSBF = 0
Tx(K1/K2): 00/00
:
/ Tx(K1/K2):
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Monitoring Per-Port Interface Statistics
BIP(B1) = 0
FEBE = 0 BIP(B2) = 0
FEBE = 0 BIP(B3) = 0
TIM = 0 TIU
PSE = 0 NSE
CLOCK RECOVERY
/
= 0
= 0
Everest 16.5
205