Cisco Asr 1000 Series Aggregation Services Routers Sip And Spa Software Configuration Guide, Cisco Ios - Cisco ASR 1000 Series Software Configuration Manual

Verifying the Configuration
DETAILED STEPS
Command or Action
Step 1
Router# configure terminal
Step 2
Router(config)# interface serial
slot/subslot/port
Step 3 Router(config-if)# ip address address mask
Step 4 Router(config-if)# clock rate bps
What to Do Next
Each port should first be connected with the appropriate cable before attempting full configuration. Some
Note
commands are enabled only based upon the cable type connected to the port.
The bandwidth of each interface is 2 MB by default; setting the clock rate does not change the interface
Note
bandwidth. We recommend that you configure the bandwidth value with the clock rate command at the
DCE and DTE side.
A clock rate of 2016000 does not appear in the configuration because it is the default value.
Note
Verifying the Configuration
After configuring the new interface, use the show commands to display the status of the new interface or all
interfaces, and use the ping and loopback commands to check connectivity. This section includes the following
subsections:
Using show Commands
The table below shows the show commands you can use to verify the operation of the 4-Port Serial Interface
SPA. Sample displays of the output of selected show commands appear in the following section.

Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS

XE Everest 16.5
278
Configuring the 4-Port Serial Interface SPA
Purpose
Enters global configuration mode.
Selects the interface to configure and enters interface
configuration mode.
Sets the IP address and subnet mask.
• address—IP address.
• mask—Subnet mask.
Configures the clock rate for the hardware to an acceptable bit
rate per second (bps).
OL-14127-17