Configuring The 8-Port Channelized T1/E1 Serial Spa - Cisco ASR 1000 Series Software Configuration Manual

Configuring the 8-Port Channelized T1/E1 Serial
SPA
This chapter provides information about configuring the 8-Port Channelized T1/E1 Serial SPA on the Cisco
ASR 1000 Series Routers.
•
•
•
Configuration Tasks
This section describes how to configure the 8-Port Channelized T1/E1 Serial SPA for the Cisco ASR 1000
Series Routers and verify the configuration. For information about managing your system images and
configuration files, refer to the following:
•
•
•
Required Configuration Tasks
This section lists the required configuration steps to configure the 8-Port Channelized T1/E1 Serial SPA.
Some of the required configuration commands implement default values that might be appropriate for your
network. If the default value is correct for your network, then you do not need to configure the command.
To better understand the address format used to specify the physical location of the SIP, SPA, and interfaces,
Note
see the
OL-14127-17
Configuration Tasks, page 223
Verifying the Interface Configuration, page 234
Configuration Examples, page 234
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
Cisco IOS Configuration Fundamentals Configuration Guide
Cisco IOS Configuration Fundamentals Command Reference
Specifying the Interface Address on a SPA, on page
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
15
C H A P T E R
228.
Everest 16.5
223