Configuring The Wan-Phy Mode - Cisco ASR 1000 Series Software Configuration Manual

Configuring the WAN-PHY Mode

Command or Action
Step 4
exit
Example:
Router(config)# exit
Step 5 show controllers wanphy 0/1/0
Example:
Router# show controllers wanphy 0/1/0
Example:
TenGigabitEthernet0/1/0
Example:
Mode of Operation: LAN Mode
Configuring the WAN-PHY Mode
This section describes how to configure the WAN-PHY mode on the 1-Port 10GE LAN/WAN-PHY Shared
Port Adapter (SPA-1X10GE-WL-V2). By default, the 1-Port 10-Gigabit Ethernet LAN/WAN PHY SPA
operates in the WAN-PHY mode.
SUMMARY STEPS
1. show controllers wanphy 0/1/0
2. configure terminal
3. hw-module subslot slot/subslot enable WAN
4. exit
5. show controllers wanphy 0/1/0
DETAILED STEPS
Command or Action
Step 1 show controllers wanphy 0/1/0
Example:
Router# show controllers wanphy 0/1/0
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
154
Configuring the Ethernet SPAs
Purpose
Exits global-configuration (config) mode and
enters privilege-exec mode.
Displays the configuration mode for the
LAN/WAN-PHY controller. The example shows
the mode of operation as LAN mode for the 1-Port
10-Gigabit Ethernet LAN/WAN PHY SPA.
Purpose
Displays the configuration mode of the
LAN/WAN-PHY controller. The example
indicates that the SPA is running in the
LAN-PHY mode.
OL-14127-17