Verifying The Interface Configuration - Cisco ASR 1000 Series Software Configuration Manual

Configuring the Circuit Emulation over Packet Shared Port Adapter
• Alarms cannot be suppressed in unframed CEM mode (SAToP). Alarms received from the remote
• The forward-alarm {ais/rai} is a hidden command and is not available in the option list. You must

Verifying the Interface Configuration

The show cem circuit command shows information about the circuit state, administrative state, the CEM ID
of the circuit, and the interface on which it is configured. If xconnect is configured under the circuit, the
command output also includes information about the attached circuit.
Router# show cem circuit
?
<0-504>
detail
interface
summary
|
Router# show cem circuit
CEM Int.
--------------------------------------------------------------
CEM0/1/0
CEM0/1/0
CEM0/1/0
CEM0/1/0
CEM0/1/0
The show cem circuit 0-504 command displays the detailed information about that particular circuit.
Router# show cem circuit 1
CEM0/1/0, ID: 1, Line State: UP, Admin State: UP, Ckt State: ACTIVE
Idle Pattern: 0xFF, Idle cas: 0x8, Dummy Pattern: 0xFF
Dejitter: 5, Payload Size: 40
Framing: Framed, (DS0 channels: 1-5)
Channel speed: 56
CEM Defects Set
Excessive Pkt Loss RatePacket Loss
Signalling: No CAS
Ingress Pkts:
Egress Pkts:
CEM Counter Details
Input Errors:
Pkts Missing:
Misorder Drops:
Error Sec:
Unavailable Sec: 5
Pkts Malformed:
The show cem circuit summary command displays the number of circuits which are up or down per interface
basis.
Router# show cem circuit summary
CEM Int.
--------------------------------------
CEM0/1/0
The show running configuration command shows detail on each CEM group:
Router# show running configuration
OL-14127-17
SAToP peer across the PSN will always be propagated over the attachment circuit.
type the full command.
CEM ID
Detailed information of cem ckt(s)
CEM Interface
Display summary of CEM ckts
Output modifiers
ID Line
1 UP
2 UP
3 UP
4 UP
5 UP
25929
0
0
25927
0
26
0
Total Active
5 5
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Admin Circuit
UP ACTIVE
UP ACTIVE
UP ACTIVE
UP ACTIVE
UP ACTIVE
Dropped:
Dropped:
Output Errors:
Pkts Reordered:
JitterBuf Underrun:
Severly Errored Sec: 26
Failure Counts:
Inactive
0
Verifying the Interface Configuration
AC
--/--
--/--
--/--
--/--
--/--
0
0
0
0
1
1
Everest 16.5
543