Configuring The Atm Spas - Cisco ASR 1000 Series Software Configuration Manual

Configuring the ATM SPAs

This chapter provides information about configuring the ATM SPAs on the Cisco ASR 1000 Series
Aggregation Services Routers.
•
•
•
Configuration Tasks
This section describes the most common configurations for the ATM SPAs on Cisco ASR 1000 Series Router.
For information about managing your system images and configuration files, refer to the following:
•
•
•
Required Configuration Tasks
Some of the required configuration commands implement default values that might or might not be appropriate
for your network. If the default value is correct for your network, then you do not need to configure the
command.
To perform the basic configuration on a primary ATM interface, complete the following steps beginning in
global configuration mode:
No data path is supported on the primary ATM interface for ATM SPAs on the Cisco ASR 1000 Series
Note
Aggregation Services Routers.
OL-14127-17
Configuration Tasks, page 59
Verifying the Interface Configuration, page 86
Configuration Examples, page 87
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
Cisco IOS Configuration Fundamentals Configuration Guide
Cisco IOS Configuration Fundamentals Command Reference
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
7
C H A P T E R
Everest 16.5
59