Cisco Asr 1000 Series Aggregation Services Routers Sip And Spa Software Configuration Guide, Cisco Ios - Cisco ASR 1000 Series Software Configuration Manual

Aggregation services routers sip and spa, cisco ios xe everest 16.5
Table of Contents

Advertisement

Required Configuration Tasks
SUMMARY STEPS
1. Router# configure terminal
2. Do one of the following:
3. Router(config-if)# ip address ip-address mask {secondary} | dhcp {client-id interface-name}{hostname
host-name}]
4. Router(config-if)# mtu bytes
5. Router(config-if)# standby [group-number] ip [ip-address [secondary]]
6. Router(config-if)# no shutdown
DETAILED STEPS
Command or Action
Step 1
Router# configure terminal
Step 2
Do one of the following:
• Router(config)# interface
gigabitethernet slot /subslot
/port.subinterface-number ]
• Router(config)# interface
tengigabitethernet slot /subslot
/port.subinterface-number ]
Example:
Example:
Router(config)#
fastethernet
slot
/subslot
.
/port
subinterface-number
]
Step 3
Router(config-if)# ip address
ip-address mask {secondary} | dhcp
{client-id interface-name}{hostname
host-name}]

Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS

XE Everest 16.5
118
• Router(config)# interface gigabitethernet slot /subslot /port.subinterface-number ]
• Router(config)# interface tengigabitethernet slot /subslot /port.subinterface-number ]
Purpose
Enters global configuration mode.
Specifies the Gigabit Ethernet, Ten Gigabit Ethernet, or Fast Ethernet interface to
configure, where:
• slot /subslot /port —Specifies the location of the interface. See the
the Interface Address on a SPA, on page
• .subinterface-number—(Optional) Specifies a secondary interface
(subinterface) number.
interface
Sets a primary or secondary IP address for an interface that is using IPv4, where:
• ip-address —Specifies the IP address for the interface.
• mask —Specifies the mask for the associated IP subnet.
• secondary—(Optional) Specifies that the configured address is a secondary
IP address. If this keyword is omitted, the configured address is the primary
IP address.
Configuring the Ethernet SPAs
Specifying
119.
OL-14127-17

Advertisement

Table of Contents
loading

Table of Contents