Cisco Asr 1000 Series Aggregation Services Routers Sip And Spa Software Configuration Guide, Cisco Ios - Cisco ASR 1000 Series Software Configuration Manual

Optional Configurations
Framing is M13, Line Code is B3ZS, Clock Source is Line
Equipment customer loopback
Data in current interval (656 seconds elapsed):
0 Line Code Violations, 0 P-bit Coding Violation
0 C-bit Coding Violation, 0 P-bit Err Secs
0 P-bit Severely Err Secs, 0 Severely Err Framing Secs
666 Unavailable Secs, 0 Line Errored Secs
0 C-bit Errored Secs, 0 C-bit Severely Errored Secs
0 Severely Errored Line Secs
0 Far-End Errored Secs, 0 Far-End Severely Errored Secs
0 CP-bit Far-end Unavailable Secs
0 Near-end path failures, 0 Far-end path failures
0 Far-end code violations, 0 FERF Defect Secs
0 AIS Defect Secs, 666 LOS Defect Secs
Configuring FDL
Facility Data Link (FDL) is a far-end performance reporting tool. In ANSI mode, you can enable one-second
transmissions of performance reports on both ends of the T1 connection. To configure FDL, use the following
commands:
Command
Router# configure terminal
Router(config)# controller t3 slot/subslot/port
Router(config-controller)# t1 number fdl {ansi}
Verifying FDL
Use the show controller command to display the FDL setting:
Router# show controller t3 3/0/1/1
T3 3/0/1 is down.
ATLAS FPGA version: 0, FREEDM336 version: 0
TEMUX84(1) version: 0, TEMUX84(1) version: 0
SUBRATE FPGA version: 0
Applique type is Channelized T3
Receiver has loss of signal.
Framing is M23, Line Code is B3ZS, Clock Source is Internal
Equipment customer loopback
Data in current interval (456 seconds elapsed):
0 Line Code Violations, 0 P-bit Coding Violation
0 C-bit Coding Violation, 0 P-bit Err Secs
0 P-bit Severely Err Secs, 0 Severely Err Framing Secs
456 Unavailable Secs, 0 Line Errored Secs
0 C-bit Errored Secs, 0 C-bit Severely Errored Secs
0 Severely Errored Line Secs
0 Far-End Errored Secs, 0 Far-End Severely Errored Secs
0 CP-bit Far-end Unavailable Secs
0 Near-end path failures, 0 Far-end path failures
0 Far-end code violations, 0 FERF Defect Secs
0 AIS Defect Secs, 456 LOS Defect Secs

Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS

XE Everest 16.5
248
Hardware is 2 ports CT3 SPA
Configuring the 2-Port and 4-Port Channelized T3 SPAs
Purpose
Enters global configuration mode.
Selects the controller to configure and enters interface
configuration mode.
(Optional) Enables FDL.
• number—Specifies the T1 channel number.
• ansi—Specifies the FDL bit per the ANSI
T1.403 specification.
OL-14127-17