Cisco ASR 1000 Series Software Configuration Manual page 522

Configuring Port Usage: An Overview
Command or Action
Step 3
Router(config-controller)# sts-1 2
Step 4
Router(config-ctrlr-sts1)# mode vt-15
Step 5
Do one of the following:
• Router(config-ctrlr-sts1)# vtg 2 t1 1 cem-group 1
unframed
•
•
•
Example:
Router(config-ctrlr-sts1)#
2 timeslots list-of-timeslots
Configuring SPA-1CHOC3-CE-ATM for SDH AU-4 C-12
To configure SPA-1CHOC3-CE-ATM for SDH AU-4 C-12, perform the following procedure:
SUMMARY STEPS
1. Router(config)# controller sonet slot/subslot/interface-id
2. Router(config-controller)# framing sdh
3. Router(config-controller)# aug mapping au-4
4. Router(config-controller)# au-4 1 tug-3 2
5. Router(config-ctrlr-tug3)# mode c-12
6. Do one of the following:
DETAILED STEPS
Command or Action
Step 1 Router(config)# controller sonet slot/subslot/interface-id
Step 2
Router(config-controller)# framing sdh
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
476
vtg 2 t1 4 cem-group
• Router(config-ctrlr-tug3)# tug-2 1 e1 1 cem-group 1 unframed
• Router(config-ctrlr-tug3)# tug-2 1 e1 1 cem-group 1 timeslots list-of-timeslots
Configuring the Circuit Emulation over Packet Shared Port Adapter
Purpose
Specifies the STS identifier.
Specifies VT-15 as the STS-1 mode of operation.
Creates a single Structure-Agnostic TDM over Packet
(SAToP) CEM group.
or
Creates a Circuit Emulation Services over Packet
Switched Network (CESoPSN) CEM group.
Purpose
Selects the controller to be configured.
Specifies SDH as the framing mode.
OL-14127-17