Configuring The Scrambling Payload Feature On T3/E3 Spa Port - Cisco ASR 1000 Series Software Configuration Manual

Configuring the Scrambling Payload Feature on T3/E3 SPA Port

SUMMARY STEPS
1. Router(config)# controller {t3} slot/subslot/port
2. Router(config-controller)# atm
3. Router(config-controller)# exit
4. Router(config)# interface atm 0/1/2.10 point-to-point
5. Router(config-if)# pvc vpi /vci
6. Router(config-if)# xconnect peer-router-id vcid {encapsulation mpls | pseudowire-class name }
7. Router(config-if)# end
DETAILED STEPS
Command or Action
Step 1 Router(config)# controller {t3}
slot/subslot/port
Step 2 Router(config-controller)# atm
Step 3 Router(config-controller)# exit
Step 4 Router(config)# interface atm 0/1/2.10
point-to-point
Step 5
Router(config-if)# pvc vpi /vci
Step 6 Router(config-if)# xconnect peer-router-id
vcid {encapsulation mpls |
pseudowire-class name }
Step 7 Router(config-if)# end
Configuring the Scrambling Payload Feature on T3/E3 SPA Port
To configure the Scrambling Payload feature on a T3/E3 SPA port, perform the following steps:
The scrambling command is supported on SPA-2CHT3-CE-ATM from Cisco IOS XE Release 3.16.4S
Note
and Cisco IOS XE Everest 16.4.1 onwards.
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
496
Configuring the Circuit Emulation over Packet Shared Port Adapter
Purpose
Selects the T3controller for the port you are configuring, where slot
/subslot identifies the SPA location and port identifies the port.
Configures the port (interface) for the clear-channel ATM. The router
creates an ATM interface whose format is atm /slot /subslot /port , where
slot /subslot identifies the SPA slot and subslot, and port identifies the
SPA port.
Returns to the global configuration mode.
Selects the ATM interface for the SPA port.
Configures a PVC for the interface and assigns the PVC a VPI and VCI.
Do not specify 0 for both the VPI and VCI. See the Configuring a
Pseudowire for an ATM Connection section for details about this
command.
Configures a pseudowire to carry data from the clear-channel ATM
interface over the MPLS network. See the Configuring a Pseudowire
for an ATM Connection section for details about this command.
Exits the interface configuration (config-if) mode.
OL-14127-17