Cisco Asr 1000 Series Aggregation Services Routers Sip And Spa Software Configuration Guide, Cisco Ios - Cisco ASR 1000 Series Software Configuration Manual

Configuring the WebEx Node
service-engine wma-url <webex url for wma spa config>
no shutdown
show hw-module subslot <subslot> service-engine status
Repeat Step 19 for all the interfaces.
Step 22 Write the configuration to memory:
Example:
write memory
Step 23 Verify that the running configuration is pointing to the correct node determined in Step 9.
Example:
show running-configuration
Step 24 Make sure that you are on the same network as the Cisco ASR 1000 Series Aggregation Services Router or VPN, and
then start a WebEx meeting.
Step 25 Verify that network traffic is traversing the WebEx SPA card on the Cisco ASR 1000 Series Aggregation Services Router
by running the following commands:
Example:
show platform hardware qfp act interface if-name service-engine0/0/0 statistics
show platform hardware qfp act interface if name service-engine0/1/0 statistics
Step 26 Access the SIP console by using the request platform software console attach slot/subslot command.
Configuring the WebEx Node Using a USB Memory Stick as a Backup
Perform the following steps to configure the WebEx Node using a USB memory stick as a backup in Cisco
IOS XE Release 3.9.1S.
If you do not want to create a backup with a USB memory device, a backup can be created through
Note
bootflash.

Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS

XE Everest 16.5
368
Configuring the Cisco WebEx Node for the ASR 1000 Series Aggregation Services Routers
OL-14127-17