Configuring The Sonet Controller For Sonet Or Sdh Framing - Cisco 10000 Series Configuration Manual

Configuring the SONET Controller for SONET or SDH Framing

E1 Channel Group Interface over AU-4-TUG-3/TUG-2
a.
b.
c.
Configuring the SONET Controller for SONET or SDH Framing
By default, the 1-Port Channelized OC-12/STM-4 line card consists of 12 STS-1 connections. To set up
the 1-Port Channelized OC-12/STM-4 line card, you must configure each STS-1 as a T3 or VT interface.
This section describes the commands used to create T3 and VT interfaces and test STS-1 connections.
This section describes the following:
•
•
•
Entering Controller-Configuration Mode
Use the controller sonet command to enter controller-configuration mode, where you can configure the
controller:
controller sonet slot/subslot/port
Where slot is 1 to 8, and subslot and port are both 0.
The following example shows you how to enter SONET controller configuration mode for a card in slot
2:
Router(config)# controller sonet 2/0/0
ROuter(config-controller)#
Cisco 10000 Series Router Line Card Configuaration Guide
6-14
In the following example, the TUG-2 interface is 1 (any number between 1 and 7), the T1 interface
is 2 (any number between 1 and 4,) and is defined as a single channel group, 5 (any number between
0 and 23). This channel group consists of all 24 DS0 timeslots.
Router(config-controller)# tug-2 1 t1 2 channel-group 5 timeslots 1-24
Router(config-controller)#
Configure the controller on an STM-4 port.
This example shows AU-4-TUG-3 controller #2 configured on port 0 of a line card in slot 2.
Router(config-controller)# controller au-4-tug-3 2/0/0.1/2
Router(config-controller)#
Set the container mode to C-12 to establish an E1 interface.
Router(config-controller)# mode c-12
Router(config-controller)#
Create an E1 interface.
In the following example, the TUG-2 interface is 1 (any number between 1 and 7), the E1 interface
is 2 (any number between 1 and 3), and is defined as a single channel group, 5 (any number between
0 and 31). This channel group consists of all 31 DS0 time slots.
Router(config-controller)# tug-2 1 e1 2 channel-group 5 timeslots 1-31
Router(config-controller)#
Entering Controller-Configuration Mode, page 6-14
Selecting SONET or SDH Framing, page 6-15
Configuring the SONET Controller Loopback Mode, page 6-15
Chapter 6 1-Port Channelized OC-12/STM-4 Line Card Configuration
OL-8834-04