Mtu Configuration - Cisco ASR 1000 Series Software Configuration Manual

MTU Configuration

Router(config-if)#
input Source MAC address on received packets
output Destination MAC address on transmitted packets
Router(config-if)#
<cr>
! Specify MAC address accounting for traffic entering the interface.
!
Router(config-if)#
! Specify MAC address accounting for traffic leaving the interface.
!
Router(config-if)#
Router(config-if)#
! Verify the MAC Address on the interface.
!
Router#
GigabitEthernet4/0/2
Input (511 free)
000f.f7b0.5200(26): 124174 packets, 7450440 bytes, last: 1884ms ago
Total: 124174 packets, 7450440 bytes
Output (511 free)
000f.f7b0.5200(26): 135157 packets, 8109420 bytes, last: 1884ms ago
Total: 135157 packets, 8109420 bytes
MTU Configuration
The following example shows how to set the MTU interface to 9216 bytes.
The SPA automatically adds an additional 38 bytes to the configured MTU interface size.
Note
! Enter global configuration mode.
!
Router#
! Enter configuration commands, one per line. End with CNTL/Z.
!
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
172
ip accounting mac-address ?
ip accounting mac-address input ?
ip accounting mac-address input
ip accounting mac-address output
end
show interfaces GigabitEthernet 4/0/2 mac-accounting
configure terminal
Configuring the Ethernet SPAs
OL-14127-17