Examples - Cisco ASR 1000 Series Software Configuration Manual

Troubleshooting the ATM SPAs
Command or Action
Step 10
Router(config-if)# no loopback
diagnostic

Examples

The following sample output shows a local loopback being set with the loopback diagnostic command:
Router# configure terminal
Router(config)# interface atm 0/2/2
Router(config-if)# loopback diagnostic
Router(config-if)# atm clock internal
Router(config-if)# end
Router# show interface atm 0/2/2
ATM0/2/2 is up, line protocol is up
Hardware is ATM SPA, address is 000a.f330.2a80 (bia 000a.f330.2a80)
MTU 4470 bytes, sub MTU 4470, BW 149760 Kbit, DLY 80 usec,
Encapsulation ATM, loopback set
Encapsulation(s): AAL5
4095 maximum active VCs, 21 current VCCs
VC idle disconnect time: 300 seconds
Signalling vc = 1, vpi = 0, vci = 5
6 carrier transitions
Last input 01:47:05, output 00:00:01, output hang never
Last clearing of "show interface" counters 01:03:35
Input queue: 0/75/33439/80 (size/max/drops/flushes); Total output drops: 963306
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
Using the loopback line Command
If an ATM interface can perform a local loopback successfully, without reporting errors, you can next try a
line loopback (loopback line command) to determine if packet errors are being generated by the ATM network
between the local and remote router. In a line loopback, the interface on the remote router is configured with
the loopback line command, so that it reflects every packet that it receives back to the originating router. The
local router then generates traffic with the ping command to determine whether the line through the network
is generating the packet errors.
OL-14127-17
Purpose
Removes the local loopback and return the ATM interface to normal operations.
Note
reliability 255/255, txload 1/255, rxload 1/255
UNI Version = 4.0, Link Side = user
9502306 packets input, 6654982829 bytes, 0 no buffer
Received 0 broadcasts (0 IP multicast)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
27827569 packets output, 21072150159 bytes, 0 underruns
0 output errors, 0 collisions, 3 interface resets
0 output buffer failures, 0 output buffers swapped out
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Remember to restore the proper clocking on the local ATM interface
and to reenable the remote ATM interface.
Using loopback Commands
Everest 16.5
99