Configuring Class-Based Unconditional Packet Marking - Cisco ASR 9000 Series Service Configuration Manual

Configuring Modular QoS Service Packet Classification and Marking on Cisco ASR 9000 Series Routers
Command or Action
Step 4
end
or
commit
Example:
RP/0/RSP0/CPU0:router(config-if)# end
or
RP/0/RSP0/CPU0:router(config-if)# commit
Step 5
show policy-map shared-policy-instance
instance-name [input | output] location
location-id
Example:
RP/0/RSP0/CPU0:router# show policy-map
shared-policy-instance Customer1 location
0/rsp0/cpu0

Configuring Class-based Unconditional Packet Marking

This configuration task explains how to configure the following class-based, unconditional packet
marking features on your router:
•
•
•
•
•
•
IPv4 and IPv6 QoS actions applied to MPLS tagged packets are not supported. The configuration is
Note
accepted, but no action is taken.
Choose only two set commands per class.
Note
OL-23108-02
How to Configure Modular QoS Packet Classification and Marking on Cisco ASR 9000 Series Routers
IP precedence value
IP DSCP value
QoS group value (ingress only)
CoS value ( egress only on Layer 3 subinterfaces)
MPLS experimental value
Discard class
Cisco ASR 9000 Series Aggregation Services Router Modular Quality of Service Configuration Guide
Purpose
Saves configuration changes.
• When you issue the end command, the system prompts
you to commit changes:
Uncommitted changes found, commit them before
exiting(yes/no/cancel)?
[cancel]:
– Entering yes saves configuration changes to the
running configuration file, exits the configuration
session, and returns the router to EXEC mode.
Entering no exits the configuration session and
–
returns the router to EXEC mode without
committing the configuration changes.
Entering cancel leaves the router in the current
–
configuration session without exiting or
committing the configuration changes.
Use the commit command to save the configuration
changes to the running configuration file and remain within
the configuration session.
(Optional) Displays statistics for the policy at the specified
shared policy instance location.
QC-29