Configuring The Pseudowire Class - Cisco ASR 900 Series Manual

MPLS Transport Profile
Command or Action
Step 3
pseudowire-static-oam class class-name
Example:
Device(config)# pseudowire-static-oam class
oam-class1
Step 4 timeout refresh send seconds
Example:
Device(config-st-pw-oam-class)# timeout refresh
send 20
Step 5 exit
Example:
Device(config-st-pw-oam-class)# exit

Configuring the Pseudowire Class

When you create a pseudowire class, you specify the parameters of the pseudowire, such as the use of the
control word, preferred path and OAM class template.
SUMMARY STEPS
1. enable
2. configure terminal
3. pseudowire-class class-name
4. encapsulation mpls
5. control-word
6. mpls label protocol [ldp | none]
7. preferred-path {interface tunnel tunnel-number | peer {ip-address | host-name}} [disable-fallback]
8. status protocol notification static class-name
9. end
DETAILED STEPS
Command or Action
Step 1 enable
Purpose
Creates a pseudowire OAM class and enters pseudowire
OAM class configuration mode.
Specifies the OAM timeout refresh interval.
Exits pseudowire OAM configuration mode and returns
to privileged EXEC mode.
MPLS Basic Configuration Guide, Cisco IOS XE Everest 16.5.1 (Cisco ASR 900 Series)
Configuring the Pseudowire Class
Purpose
Enables privileged EXEC mode.
23