Configuring The Duplex Mode For A Management Ethernet Interface - Cisco 6000 Series Configuration Manual

Advanced Configuration and Modification of the Management Ethernet Interface
Command or Action
Step 7 show interfaces MgmtEth interface-path-id
Example:
RP/0/RP0/CPU0:router# show interfaces MgmtEth
0/RP0/CPU0/0

Configuring the Duplex Mode for a Management Ethernet Interface

Perform this task to configure the duplex mode of the Management Ethernet interfaces for the RPs.
SUMMARY STEPS
1. configure
2. interface MgmtEth interface-path-id
3. duplex [full | half]
4. Do one of the following:
DETAILED STEPS
Command or Action
Step 1 configure
Example:
RP/0/RP0/CPU0:router# configure
Step 2 interface MgmtEth interface-path-id
Example:
RP/0/RP0/CPU0:router(config)# interface MgmtEth
0/RP0/CPU0/0
Step 3 duplex [full | half]
Example:
RP/0/RP0/CPU0:router(config-if)# duplex full
Step 4 Do one of the following:
• end
• or
• commit
Interface and Hardware Component Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
• end
• or
• commit
• or
Configuring the Duplex Mode for a Management Ethernet Interface
Purpose
(Optional) Displays statistics for interfaces on the router.
Purpose
Enters XR configuration mode.
Enters interface configuration mode and specifies the
Management Ethernet interface name and instance.
Configures the interface duplex mode. Valid options are
full or half.
Note To return the system to autonegotiated duplex
operation, use the no duplex command.
Saves configuration changes.
• When you issue the end command, the system prompts
you to commit changes:
15