Configuring The Wan (Internet) Connection - Cisco UC 320W Administration Manual

System Readiness

Configuring the WAN (Internet) Connection

NOTE
Configuring the WAN (Internet) Connection
TIP
NOTE
Unified Communications UC 320W Administration Guide
• AA/VM Language: The language for the pre-recorded prompts to be used
by the Auto Attendant and Voicemail system
• Internal Dialing: The allowed dialing sequences
• Call Tones: The call processing tones
To import localization files:
Click Custom. Then click an Import button, find the file that you want to import, and
double-click to select it.
Only English is available for Phone Language and AA/VM Language currently. For
Dial Plan and Call Tones, North America, UK, and Hong Kong are supported.
Use the WAN page to configure your Internet connection, as needed.
Opening this page: From the navigation pane, choose System Readiness > WAN.
The UC 320W is preconfigured to obtain a public IP address dynamically from
your Internet Service Provider (ISP) by using Dynamic Host Configuration Protocol
(DHCP). Depending on the requirements of your ISP, you may need to change the
WAN connection settings. Refer to the account information provided by your ISP.
If you do not have the information to configure your WAN connection at this time,
you can click the Next button to proceed. When you apply your configuration on the
System Readiness page, an error message will appear. However, you will be able
to use a Skip button to continue to the next phase of the setup process. Later, you
can save your session; reload it when you are ready configure your WAN
connection.
Enlarge picture:
Check this box if you want to view the picture at a larger size, for easier reading.
View System Map:
Click this link to view an illustration of the devices and services in the Unified
Communications System.
3
50