After the users select a mode, and save the setting, they can start CANopen Builder by means
of Intelligent Module Configuration.
15.4.2 Using CANopen Builder to Configure a Network
1. After users click Online, the software will read the settings in AH10COPM on the backplane
used.
2. After Online is clicked, the mode, backplane number, slot number, and node address of the
module will be brought out by the software. After the users right-click the master station selected,
and click Scan DeviceNet Network on the context menu which appears, the information about
the node devices on the network created will be scanned.
Ch a pt er 1 5 C AN o pe n Communication M o du l e AH 1 0CO P M
15-9