3. Select "Enable" for "Extend Baud rate Enable" in the following parameter editor.
Meanwhile, select the desired baud rate for "Extend Baud rate" as follows.
Click "OK" to return to the main interface of the software after downloading is completed.
Note: These parameters in the parameter editor belong to the current slave.
4.
After downloading is completed, turn both of the function switch DR0 and DR1 of
AH10DNET-5A (Slave) to ON and then repower the AH500 series CPU module. At the time, the
extension baud rate setting is finished.
Ch a pt er 1 0 De v ic eN e t Com m unic at i on Mo d ul e A H 10 DN ET
1 0 - 4 1