Delta AH500 Manual page 451

Item
The output data mapping range of each module which depends on the
Output
start address offset and length of output mapping data
Comment Remark for the I/O modules on the rack
Click "OK" to exit from AHRTU-DNET-5A configuration interface and then
OK
the current configuration will be stored.
Click "Cancel" to exit from AHRTU-DNET-5A configuration interface but
Cancel
the current configuration will not be stored.
4. Click the right-side "Scan" button on the following "AHRTU-DNET-5A Configuration" interface.
The abnormal icons may appear after scanning the I/O modules connected to AHRTU-DNET-5A
is completed. The explanation of the abnormal icons is listed in the following table.
The I/O module configured in the software does not match that actually
connected. For example, the I/O module inserted to slot 4 in the rack 1 in the
software is 32AM. But actually, it is 16AP connected. After scanning, the icon
as left one is shown. Double click the icon and change it into the current
configuration icon.
The I/O module configured in the software does not match that actually
connected by scanning. For example, the I/O module inserted to slot 4 in the
rack 1 in the software is AH04AD-5A. But actually, no such a module is
connected. After scanning, the icon as left one is shown. Double click the icon
and change it into the current configuration icon.
Ch a pt er 11 DeviceNet Re m ote I/O Module AHRTU-DNET
Description
11-25