Delta AH500 Manual page 703

24. Click "Station Table" on the left-side window and then click the red box on the right-side window
to modify the node address of the slave on the software.
(Note: Pick the place of "Activate" column as below. Otherwise, the configuration data of the
slave will be invalid.)
25. Click "Master Settings" on the left-side window to set the master parameters.
(The settings here are default. For the meaning of each item, please refer to section 10.3.2 in
the SYCON.net help.)
When there is an IW or QW-type module and its offset address does not start at 0 or an even
number, user could tick "2 Byte boundaries" to adjust and make the offset address of each
module start at 0 or an even number for the purpose of easy program control.
Chapter 14 Remote I/O Communication Module AHRTU-PFBS
14-73