Operation mode
The data exchange function can be always enabled, controlled by a program, or enabled when
a PLC runs. If the data exchange function is always enabled, AH10/15EN-5A will execute the
function continually. If the data exchange function is controlled by a program, the function will be
controlled by the setting value in an output register. If the data exchange function is enabled
when a PLC runs, the status of the PLC will be detected. When the PLC runs, the function is
enabled.
Station address and IP address
Users need to enter the IP address and the station address of a slave station.
Initial register in a master station, initial register in a slave station, and number of data
Input: Initial reception register in a master station←Initial transmission register in a slave station
Output: Initial transmission register in a master station→Initial reception register in a slave
station
Number of data: A slave station can send 100 pieces of data at most and receive 100 pieces of
data at most simultaneously.
Ch ap te r 9 Ether ne t Co mmun ica tio n Mo du le AH1 0 /1 5 EN
9 - 3 1