Delta AH500 Manual page 387

5. Double click 10DNET icon in the above window and the parameter configuration interface of
AH10DNET-5A will pop up as follows.
Double click "Parameter of IO Mapping" on the above window; set the value in "Parameters of
IO mapping" and the set value is the starting address of the mapping area. Click "OK" after
setting is over.
Note: The set value is the starting address of the mapping area. Both of the length of the input
and output mapping areas is 500 words.
6. Right click 10DNET icon in the HWCONFIG software interface and then select "Intelligent
Module Setting".
Ch a pt er 1 0 De v ic eN e t Com m unic at i on Mo d ul e A H 10 DN ET
1 0 - 2 5