Delta AH500 Manual page 778

AH500 Module Manual
Error
Category
code
16#1003
Firmware
16#1004
error
16.7.2.2 I/O Module Error
Error
Category
code
I/O module
configuration 16#2001
error
Backplane
configuration 16#2002
error
Extension
backplane 16#2003
offline
16.7.2.3 Communication Error
Error
Category
code
EtherNet/IP
communication 16#0106
error
16#0113
EtherNet/IP
communication
error
16#0100
16#0203
16-28
7-segment
Explanation
display
Modify the IP
- address when in
RUN state.
Firmware update
F7
failure
7-segment
Explanation
display
Actually connected
I/O module is
F9 different from that
configured in the
software.
Actually connected
backplane is
F8 different from that
configured in the
software.
The connection
between the main
backplane and
FA
extension
backplane are
disconnected.
7-segment
Explanation
display
Ownership
-
conflict
Out of
-
connections
I/O
- connections
duplicated
I/O
E3
connection
How to deal with
-
1. Check if the two ends of the
network are connected
properly.
2. Perform the firmware update
again.
How to deal with
1. Re-install I/O module
2. Repower ON
3. Re-download the
configuration.
1. Re-install the backplane
2. Repower ON
3. Re-download the
configuration.
1. Check if the cable connection
is normal.
2. Repower ON
How to deal with
1. Check the scanner owner.
2. Modify the invalid scanner
setup.
3. Change the connection into
Multicast.
1. Check if the number of product
connections exceeds the limit.
2. Reduce the number of product
connections.
1. Check if I/O connections have
been built in the system
configuration.
2. Change the connection type
into Listen Only.
1. Check if the network cable
connection is normal.