Delta AH500 Manual page 504

AH500 Module Manual
The communication format and the mapping relations between the AC motor drive and the DVP-SV
series PLC are shown below.
Station Communication
Product
address
38400, ASCII
VFD 10
38400, ASCII
PLC 5
11.6.2 AH10SCM-5A Configuration
11.6.2.1 Configuration of AH10SCM-5A Parameters
Make the communication and call the DeviceNet Builder software by following the steps introduced
in section 5.2.1 and 5.2.2. And the start addresses of AH10DNET-5A for the input and output are
D1500 and D1000 respectively.
Select the network to be scanned in Project List and then click "Scan DeviceNet Network" button to
begin to scan the nodes on the network. If scanning fails, please ensure that the selected master
must be AH10DNET-5A in Project List.
11-78
Read
format address
16#2103
7, E, 1
D100~D109
7, E, 1 M100~M109
CPU buffer Write
register address
16#2000
D1540
16#2001
D1550~D1559
D200~D204
Bit 0 in D1560~
M200~M204
bit 1 in D1561
CPU buffer
register
D1020~D1021
D1030~D1034
Bit 0 in D 1040
~bit 1 in D1040