AH500 Module Manual
Product picture
11-16
Type
Used for connecting the E series AC motor
CME-DN01
drive to the DeviceNet network.
Used for connecting the C2000, CH2000,
CMC-DN01
CP2000 series AC motor drive to the
DeviceNet network.
It converts DeviceNet to Modbus gateway
with the DeviceNet interface at one end and
DN-02
the RS485 port at the other end. It is used
for connecting the AC motor drive to the
DeviceNet network.
Used for connecting the S series PLC CPU
to the DeviceNet network. The module can
DVPDT01-S
be connected to the extension port in the
right side of the S series PLC CPU.
Used for connecting the DVP-EH2/EH3
series PLC CPU to the DeviceNet network.
DVPDT02-H2
The module can be connected to the
extension port in the right side of
DVP-EH2/EH3 series PLC CPU.
The CAN bus topology tapping box with the
120 ohm resistor enclosed which is
TAPCP01
controlled to be effective or not via its
switch.
Function