Delta AH500 Manual page 572

AH 5 00 Mo d u le Ma n ua l
Select "<Slot 2> 2 Word Out 2 Word In" in the box marked in red and then double click the place
marked in blue as below so as to set the starting addresses for input and output of the configured
module.
Name
Input mapping
(slave->master)
Output mapping
(master->slave)
Note: the initial D register No. of each configured module must be set up separately.
Click "Signal Configuration" on the left-side window and then the detailed information about the
configured module appears on the right-side window. The input and output data lengths of
configured module on the above window can be seen from the following window.
The configured module of the slave corresponds to the mapping parameter of the slave as follows.
Configured module of slave
4 Word Out, 4 Word In
1 2 - 3 6
Setting
The initial number of the D
registers in the slave PLC (The
register is for sending data to the
master)
The initial number for the D
registers in the slave PLC (The
register is for receiving data that
the master transmits).
Output_1
Output_2
Output_3
Output_4
Input_1
Input_2
Input_3
Input_4
Value
D500
D600
Mapping parameter of slave
D300
D301
D302
D303
D200
D201
D202
D203