Delta AH500 Manual page 571

Select "<Slot 1> 4 Word Out 4 Word In" in the box marked in red and then double click the
place marked in blue as below so as to set the starting addresses for input and output of the
configured module.
Name
Input mapping
(slave->master)
Output mapping
(master->slave)
（Note: the initial D register No. of each configured module must be set up separately.）
Ch a pt er 1 2 N e t wor k Mo d u le AH 10 P F BM
Setting
The initial number of the D
registers in the slave PLC (The
register is for sending data to
the master)
The initial number for the D
registers in the slave PLC (The
register is for receiving data
that the master transmits).
Value
D200
D300
1 2 - 3 5