Building And Starting The Communication Channel Driver 1 In Commgr - Delta AH500 Manual

3. Ensure that the baud rates of AH10DNET-5A and AHRTU-DNET-5A are same.
Module
AH10DNET-5A
AHRTU-DNET-5A
4. Add 24 V network power between V+ and V- and the 120 ohm terminal resistor between CAN_H
and CAN_L.
11.5.2 Using DeviceNet Builder to Configure the Network
11.5.2.1 Building and Starting the Communication Channel Driver 1 in
COMMGR
Open COMMGR and the following interface will appear.
Click "Add" button to add a communication channel Driver 1 and set up the channel as follows.
Ch a pt er 11 DeviceNet Re m ote I/O Module AHRTU-DNET
Station address
3
1
Baud rate
500 kbps
500 kbps
11-59