Delta AH500 Manual page 343

CR
Number
control
register
#645 K100
#646 K1
#647 K0
#620 K45
CR#650 ~ CR#659: Setting up the data point for the database of the slave station

Example: AH15EN-5A as a slave, when creating data M_SP IOA 100 ~ IOA 104 to the

database and corresponding to M100 ~ M104 of the CPU register, users can input the values
according to the table below and trigger to create. The same rule applies to 2
devices. Refer to section 9.3.5 for details on type id parameters and codes.
CR
Number control
register
#650 K5
#651 K1
#652 K100
#653 K0
#654 K1
#655 K0
#656 K0
#657 K0
#658 K100
#659 K1
CR#672 ~ CR#684: Setting up the starting position of the corresponding CPU register for the

1 st connection of the type id of the remote device. One word represents one type id.
CR Description
Number
#672 Single-point information corresponds to the starting position of M device
#673 Double-point information corresponds to the starting position of M device
#674 Step position information corresponds to the starting position of D device
#675 Bitstring of 32 bit corresponds to the starts position of D device
#676 Measured value, normalized value corresponds to the starting position
from D500
#677 Measured value, scaled value corresponds to the starting position of D
device
#678 Measured value, short floating point value corresponds to the starting
position of D device
#679 Integrated totals corresponds to the starting position of D device
#680 Event of protection equipment corresponds to the starting position of D
device
#681 Packed start events of protection equipment corresponds to the starting
position of D device
#682 Packed output circuit information of protection equipment corresponds to
the starting position of D device
Ch ap te r 9 Ether ne t Co mmun ica tio n Mo du le AH1 0 /1 5 EN
Value
in the
IOA 100 (information object address) of the remote device
1：ON，0：OFF
Single command code
Value
in the
Add 5 data points
Type identification, 1: M_SP_NA_1
The starting position of IOA is 100.
Group mask, 1: group 1 station interrogation
Flags = 0
Default value = 0
The starting position of CPU register is M100.
1: trigger to create
Description
nd
Description
~ 16 th remote
9 - 1 3